To
adjust the head race bearing's You'll need to remove the top
yoke, you don't really need to remove the screen brace, but
I would suggest you do, as it makes life a bit easier.
If your going
to remove the screen brace, you'll need to remove both mirror's
and the two front fuel tank mounting bolts |
|
|
|
|
Undo
the the top yoke clamp bolts as the picture. (pic
1) above
|
Undo
and remove the top stem nut.
|
|
|
|
|
Gently
prise the top yoke up and away from the forks.
|
Using
a screw driver prise the tab down on lock nut, and remove
the upper nut.
|
|
|
|
|
Using
the Preload spanner from the tool kit, Tighten the head
races so you get slight resistance.
|
Put
the locking washer on the lower nut and screw the upper
locking nut down
|
while
holding the lower nut, tighten the upper nut through a further
90 degree's so the slots aligned with the locking tab's.
|
|
Finally;
put the top yoke back on, put the top stem nut on and screw
it down, then torque it up to 76 ft-lbs. Tighten all the
other bolts in the handle bars clamps to 17 ft-lbs and the
top yoke clamp bolts to 17 ft-lbs.
|
